Many friends use the stainless steel (stainless acid-resistant steel) piston (piston) rod, they found that he will be beating, then you know the cause of the cause of this problem? In addition, we should also do a good job of inspecting stainless steel piston rods. Only in this way can we prevent damage, and I don't know how you look at this problem. I hope that in the following introduction, we can find answers. The 45# piston rod connects the piston and the crosshead to transmit the force acting on the piston and drive the piston to move.
 
1,  Stainless steel (stainless acid-resistant steel) Piston rod jump problem (Emerson)
In fact, in the stainless steel (stainless acid-resistant steel) piston rod, he is still relatively normal, so the cause of the stainless steel piston rod (Emerson) will die in the piston rod, he will have a deflection, in addition He also has displacements in the cylinder (compressed air) and the slide, which causes the tilt to occur. The hydraulic piston rod cylinder, the piston rod (cylinder rod), the piston and the end cover are composed of several parts. There may also be gaps between the pistons and the cylinders, so these problems can cause our stainless steel piston rods to jump. So we should still be ready for the job. Of course, he may be caused by other reasons, and we should also find out.
 
2,  Stainless steel piston (piston) rod damage truth
Many friends did not ensure that the gas and cylinder were in one position when installing the cylinder. This would result in a relatively large liquid in the gas, so we should still look at how his position changes. . When the hollow piston rods have the same material and the cross-sectional area is equal, the hollow piston rod has stronger torsion resistance and can withstand large external moments. When we are working on a stainless steel (stainless acid-resistant steel) piston rod, if the angle of the thread is relatively small, then it is possible that there will be a problem of deviation (Emerson), so that It is likely to cause damage. In addition, we should also do a good job in the design of stainless steel piston rods, I hope everyone can be better to complete these aspects of work.
 
In fact, there are still many places where stainless steel (stainless acid-resistant steel) piston rods are used in our normal life. I just don't know how much they know about them. The hydraulic piston rod cylinder, the piston rod (cylinder rod), the piston and the end cover are composed of several parts. The 45# piston rod supports the connecting parts of the piston work. Most of them are used in the cylinder and cylinder movement executing parts. It is a moving part with frequent movement and high technical requirements. If something really happens in the course of the job (guò ché ng) (Emerson), we should also solve and deal with it in time.
 
 
 

• prev：Excellent performance of stainless steel piston rod after ro
• next：Why is our piston rod always bad, what caused it?