It should be no stranger to say about the piston rod, but if you want to further improve the performance of the piston rod, then naturally we should know what we need to pay attention to in this process. The hydraulic piston rod cylinder, the piston rod (cylinder rod), the piston and the end cover are composed of several parts. When the hollow piston rods have the same material and the cross-sectional area is equal, the hollow piston rod has stronger torsion resistance and can withstand large external moments. In order to be able to explain this problem better (Emerson), we also went to ask some friends, I hope to help everyone's operation control.
 
1,  The key point of piston rod wear
In fact, some problems (Emerson) are common in our process of using the piston rod (guò ché ng), but you know how we should complete the operation control of the piston rod. The hydraulic piston rod improves the surface corrosion resistance and can delay the generation or expansion of fatigue cracks, thereby improving the fatigue strength of the cylinder rod. The 45# piston rod supports the connecting parts of the piston work. Most of them are used in the cylinder and cylinder movement executing parts. It is a moving part with frequent movement and high technical requirements. The hydraulic piston rod cylinder, the piston rod (cylinder rod), the piston and the end cover are composed of several parts. In fact, the cause of frequent frequency damage of the piston rod is that the center of the cylinder and the piston rod are not in common, so that there will be an angle, and then we will have a bending condition when we are doing the work (Condition). appear. If the situation is serious, it is possible that there will be impacts. These problems are the causes of wear (a basic type of component failure), so we should pay more attention to the actual operation. .
 
2,  Piston rod installation attention point
When we install the piston rod, we should naturally ensure that it is chamfered inside the cylinder. In addition, we need to install the sleeve when installing. I don’t know when you are in control. Is there any deburring? Of course, some impurities should be cleaned and parts should be cleaned. Only then can we ensure that the quality of the piston rod is not affected. Of course, we can also apply some lubricating oil when installing stainless steel (stainless acid-resistant steel) reactor, so that we will operate relatively smoothly and conveniently. The work in these aspects is also not enough.
 
No matter how you look at the piston rod, but since you need to use it to complete related operational controls, then naturally we should also guarantee his integrity. I don't know if our introduction will help everyone's operation. We also look forward to the opportunity to collaborate with everyone.
 
 
 

• prev：The importance of polishing and assembly for the piston rod
• next：All the techniques that should be in operation with stainles